RE: Outputting the contents of cursors in a Report Summary

Author: Tracy Pearson

Posted: 2015-07-01 at 14:38:33

Joe Yoder wrote on 2015-07-01:

> I was planning on the formatting capabilities of the report writer. I

> guess one possibility would be to create a separate Summary Report and

try

> to 'glue' the two reports together into a single PDF. Any simple way to

do

> that?

>

Joe,

It has been a long time since I worked with related cursors in a report. So

this is from memory.

Your primary cursor will relate to the cursors that will run in the detail

bands.

Using the Target Alias Expression sets which cursor will be looped in that

band. (Found on the Detail Band Properties)

To prevent a band from printing, the filtered group will need to have no

records.

Adding a third cursor would be the same as adding the second you already

have.

If the Detail Header/Footer values print/display, then you can use the Print

When expression to see if you are !EOF("SummaryCursor") .

HTH,

Tracy

Tracy Pearson

PowerChurch Software

_______________________________________________

Post Messages to: ProFox@leafe.com

Subscription Maintenance: http://mail.leafe.com/mailman/listinfo/profox

OT-free version of this list: http://mail.leafe.com/mailman/listinfo/profoxtech

Searchable Archive: http://leafe.com/archives/search/profox

This message: http://leafe.com/archives/byMID/profox/000301d0b435$849e0800$8dda1800$@powerchurch.com

** All postings, unless explicitly stated otherwise, are the opinions of the author, and do not constitute legal or medical advice. This statement is added to the messages for those lawyers who are too stupid to see the obvious.

©2015 Tracy Pearson